Seal Pro WaterProofing Sealer is a moderate gloss clear protective coating for use on: interior/exterior concrete, masonry, stucco, brick, stone, slate, interlocking pavers, concrete roof tile, exposed aggregate, keystone, and cut coral, as well as many other types of decorative concrete surfaces. It waterproofs and dustproofs the surface while providing a high resistance to abrasion.

Seal Pro WaterProofing Sealer has a very high glass transition point which provides excellent resistance to scratching and marring in hot climates and is formulated to exhibit a high degree of resistance to U.V. sunlight. It provides a deep rich look to any finish while providing excellent resistance to water, dirt and grime, oil, grease, rust, acid, chlorine, fertilizer stains, and mildew, as well as stains from most other organic matter. Seal Pro Waterproofing Sealer is non-yellowing, does not turn "cloudy" and may be used on horizontal and vertical surfaces.

Seal Pro WaterProofing Sealer is a special blend of modified acrylic polymers. It is the result of over 25 years of research and development in the Architectural Paving Industry and has been tested and proven on millions of square feet. 

The surface should be cleaned of dirt, oil, grease, rust and any other foreign matter and allowed to dry completely. Seal Pro WaterProofing Sealer may be applied to un-sealed concrete surfaces using roller, brush or spray equipment. Coverage rates will vary depending on the porosity of the surface, usually around 100 - 200 square feet per gallon. Allow two hours for pedestrian traffic and twenty-four hours for vehicular traffic.

Please note: Not all coatings in the industry are compatible. If your surface has a previously applied coating, complete removal is usually recommended. Application of any sealing product over previously applied coatings does not correct any deficiencies in existing coatings and is no guarantee of future performance.

Please complete our "Free Estimate" form to receive a cost estimate for your project.